This splicer was pulled from service in excellent condition. We
guarantee against DOA but not calibration. ARC count shown is
1557. The instruction manual is included with the splicer.
Fujikura FSM20RS Ribbon fusion splicer utilizes a PAS (Profile
Alignment System) that aligns the core of single-mode and the
cladding of multimode fibers. A built in monitor allows
cross-sectional viewing of the prepared fiber ends, and displays
cleave angle and estimated splice loss. the system will splice
both single-mode and mult-mode fibers. Alignment, fusion and
splice loss estimation are automatically completed by the
built-in computer. Applicable fibers: SMF at 1310nm; DSF at
1550nm; GI fibers. Average splice loss: 0.03 dB (SMF); 0.05 dB (DSF);
0.02 dB (GI). Includes a built-in tube heater for installing
splice protective sleeves. AC- or external 12 Vdc- powered.